Page 1 of 1
Melbourne - Recommend Someone to Resleeve a 29 Cylinder?
Posted: Tue Apr 24, 2012 7:35 am
by Pleiades
After a dropper valve caused a big, nasty bang at the end of the PI straight last year, I need to get cylinder #4 in my NC29 motor resleeved. Any suggestions on who in Melbourne might be able to help me? I've spoken to C&C, interested in other options.
Cheers,
David
Re: Melbourne - Recommend Someone to Resleeve a 29 Cylinder?
Posted: Fri May 11, 2012 2:35 am
by Cammo
No idea mate, I would've suggested C&C also!
It might be worth asking RB Imports for advice.
Re: Melbourne - Recommend Someone to Resleeve a 29 Cylinder?
Posted: Sat May 12, 2012 6:20 pm
by Pleiades
Hey Cam, I was chatting to GF on email, and he suggested that he'd never had any luck getting a 29 motor successfully resleeved, so I pulled the pin. As noted elsewhere, I'm moving to Amsterdam in August, so not sure whether I'll be putting my bike back together before I leave. Will decide in the next few days.
Re: Melbourne - Recommend Someone to Resleeve a 29 Cylinder?
Posted: Mon May 14, 2012 6:43 am
by Cammo
Yeah I wasn't sure that these engines could be resleeved, nc30's are in the same camp.
All the best on your globe-trotting mate!
Re: Melbourne - Recommend Someone to Resleeve a 29 Cylinder?
Posted: Sat May 19, 2012 9:32 pm
by stimpy
big bore,,,,time for the big bore
Re: Melbourne - Recommend Someone to Resleeve a 29 Cylinder?
Posted: Mon May 21, 2012 8:41 am
by kiwi racer
Re: Melbourne - Recommend Someone to Resleeve a 29 Cylinder?
Posted: Wed May 23, 2012 10:40 pm
by Pleiades
stimpy wrote:big bore,,,,time for the big bore
