nc24 clutch torque setting
Posted: Wed Apr 04, 2012 6:02 pm
Hello everyone, just a quick one, does anyone know the torque setting for the 4 bolts on the clutch pressure plate? cheers bobby
http://www.400greybike.com/forum/
nc24 clutch torque setting
Page 1 of 1
Re: nc24 clutch torque setting
Posted: Wed Apr 04, 2012 7:04 pm
IIRC it's about 18Nm
Re: nc24 clutch torque setting
Posted: Wed Apr 04, 2012 8:31 pm
Thanks mate i'll go with that then, I havn't got a manual for the nc24 in fact I have never seen one..
Re: nc24 clutch torque setting
Posted: Wed Apr 04, 2012 8:32 pm
Unless you can read Mandarin, it would be useless to you anywaybobby wrote:I havn't got a manual for the nc24 in fact I have never seen one..
Re: nc24 clutch torque setting
Posted: Thu Apr 05, 2012 3:22 am
The haynes manual for the NC30 has most of the torque figures for the NC2x in the rear.
Those arn't listed as a specific component. So just torque them up to generic values for that size of bolt
Those arn't listed as a specific component. So just torque them up to generic values for that size of bolt