Just got myself a few miss matched parts, nc30 frame, nc24 engine and a complete swingarm with brake and shock from a 750.

I have had the swingarm for years as it was going to go into a streetfighter gsxr.
I was given the frame by a mate, who stripped it for spares and was going to scrap it.
Engine is the same, sitting in a container for years and it has a damaged / holed clutch cover.( something has dropped on it).
I have the offer of the nc24 loom, not sure of the cost.
The bike will only be a trackbike, due to the category frame.

If anyone has put that engine in the frame, or done a 750 swingarm swap, please post, as this would save me a lot of head scratching.

Cheers,

Nik

Loom should cost no more than about £20 for a mint one. Any more than that, start looking on eBay

24 engines have been put into 30 frames and the 750 swingarm has been fitted numerous times. Just browse the members bikes section or the VFR workshop section