right , i want to fit my R&G non cut bungs to my bike this weekend but ive noticed from the guide im missing two bolts to hold the brackets into the actual fram of the bike , i need 2 of these



anyone know what the thread is i need so i can try source some before the weekend ?

cheers guys

10x40mm i belive

if i was to get a 40 or 50mm it wouldnt matter to much would it , just means one bolt will thread in further then the other ?

i guess so , just lookin on the parts manual and it states bolt, flange, 10x40 , im sure someone will be along to confirm though
have a look here http://www.400greybike.com/files/NC30.L ... Manual.pdf