Hi all,

I think I already know the answer to this, but I'm after the left switchgear for a 91 NC30 L but eBay and suchlike isn't coming up trumps.. I've found a couple of sellers with the NC35 version and a quick look in the Haynes manual circuit diagrams suggest they're different (some kind of dimmer arrangement on the later model), but I was wondering if anyone knew whether I could make it work?

Cheers

i remember asking this exact same question last year...

to answer your question, yes you can make it work...is it worth it? probably not seeing as you could stick up a WTB thread in the classified section of the forum and have a 30 switch by the end of the week instead of trying to fettle with the 35 switch

it would be a lot of chopping wires and losing the connector blocks that join them. they are different...

i may have an untidy LH switchgear in me shed. but i wont be able to check for a few days.. PM me a reminder and i'll look this week.

No, the 35 lights are permanently on and cannot be switched off as such that area is blanked off.

why not just but a nc30 switchgear , dont cost a lot

http://www.ebay.co.uk/itm/HONDA-VFR400- ... 3cc142ed43

sam

Spot on, thanks for the replies chaps..

Just as I thought then really, turns out some NC30 ones have appeared on eBay since too :-)

I'll pop you a PM though hardnut, could save me some messing about :)