is it going to be like pandoras box in there lol

having to fiddle with the switch to get the lights on so must have a lpose connection

NC30?

If you've not done the high beam relay mod then it could of melted inside and you'll need a new unit.

leerc wrote:is it going to be like pandoras box in there lol

having to fiddle with the switch to get the lights on so must have a lpose connection

AS above.. sounds like switch is melted.

If you put normal H4 headlamps into the bike (60/55w) they will melt a Japanese bikes switch gear

yeah its a jap nc30, im sure they are h4 bulbs thst are in and 60/55 rings a bell i only replaced what was alreay in so have no idea if its had the relay mod done

since i bought it iv never been off high beam as low was useless and both jap and uk bike are 60w high

leerc wrote:yeah its a jap nc30, im sure they are h4 bulbs thst are in and 60/55 rings a bell i only replaced what was alreay in so have no idea if its had the relay mod done

since i bought it iv never been off high beam as low was useless and both jap and uk bike are 60w high

Are your headlights aimed properly and clean?

I have standard 35/60w H4R bulbs and the low-beam is fine?

i havnt checked but i think its me being used to the car HID i have in the car

i had that problem.

its a simple fix, but it relapses sometimes.

you could install an external on-off switch for convenience sake!

does anoyone have any pictures of this relay mod when its done?
and where i can get hold of the correct relay?

makz2008 wrote:does anoyone have any pictures of this relay mod when its done?
and where i can get hold of the correct relay?

Any cheap automotive 20A relay will be fine.

http://www.vsource.org/VFR-RVF_files/NC ... mRelay.htm

Thers some pictures here