As the title states who would be interested in some as I have had 2 requests today and am thinking of have some made up

Depends on price really mate but I fancy some.

Did you get my pm about the subframes?

I wanted to buy some of these in the past so yes i would be interested obviously depending on price

tanuki wrote:Depends on price really mate but I fancy some.

Did you get my pm about the subframes?

yeah got the mail on the subframes and I may be interested but it depends on what needs to be done to finish it off as I dont want to have to fanny about trying to source brackets to get the seats to fir properly.

On the engine case covers we normaly retail them around the £129.00 mark but with it being grey bike I will be able to do them a little cheaper than that a set around the £110.00 mark. I will need about 10 orders/sets to get the guys to do them so if we can get that many then I will get some made (will need 10 deposits though so that I know I have definate orders)

How will they be finished, plain carbon or will the kevlar show aswell?

the ones we already do for other models are full kevlar on the inside with a skin of normal carbon on the outside. If demand for full kevlar is wanted then me may be able to go down that route

here is a link for a set we do for a R1

http://www.ebay.co.uk/itm/JAP4-YAMAHA-Y ... 3f0f788659

I may be interested in a set. Would it be 2 pieces? And that price is $129 would these be lets say..... $90?

cajun wrote:I may be interested in a set. Would it be 2 pieces? And that price is $129 would these be lets say..... $90?

Not sure how many pieces yet will decide that when we and if we get some done (depending on orders) Prices as listed above approx Full retail is £129.00 (not dollars) grwey bike price will be £110.00 approx again pounds not dollars

I believe I was one of those emails. I'm in, and I'll ask around some of the NC29 racers here in the colonies.

I see that the R1 set has bolt holes. That would be awesome on the NC29 ones, as our supp regs specify that our case covers "must be fixed properly and securely. Bonding alone is not a suitable method of mounting"

I will check to see what we can do about bolting them on.