• HRC velocity stacks or not..?

Posted: **Thu Oct 13, 2011 12:17 pm**

Afternoon,

Any HRC experts out there? Trying to work out if my NC35 velocity stacks are HRC or just two sets of standard short ones...

Ta,
James

Posted: **Thu Oct 13, 2011 12:46 pm**

the odds are they are 2 std short ones.. Not sure I've seen any proper short ones

Posted: **Thu Oct 13, 2011 1:11 pm**

that's what I figure but have failed to find any definitive dimensions anywhere. I think you're probably right though. No ebay fortune for me...

Posted: **Thu Oct 13, 2011 1:17 pm**

I think I have a brand new in the bag set at home, I will try and dig them out and measure them for you

Posted: **Thu Oct 13, 2011 1:37 pm**

Brand new HRC bits just kicking around at home? That's a bit flash.

Posted: **Thu Oct 13, 2011 1:41 pm**

Im a bit of a hoarder. From memory I think the HRC ones are 20mm rather than the standard short ones being 30mm but may be wrong

Posted: **Thu Oct 13, 2011 2:17 pm**

^^This is what I reckon too^^

Posted: **Thu Oct 13, 2011 4:21 pm**

Stanfard are 20mm hrc are 30mm

Posted: **Thu Oct 13, 2011 4:37 pm**

Which makes them standard. Thanks all...

Posted: **Thu Oct 13, 2011 5:00 pm**

Drunkn Munky wrote:Stanfard are 20mm hrc are 30mm

Knew it was something like that

HRC velocity stacks or not..?