Just wondering what other people have done in terms of block connectors, or just putting individual heatshrinked spade connectors onto the wires going into the reg/rec. I ask because my connector block on the loom is either corroded/melted into the bottom of my defunct reg/rec so I will need to snip the wires out before I can put the r6 one in.

I've seen 5 pin connector blocks on eBay but just wondered if anybody had experience of this and what they thought was best / where to get hold of the bits I need.

Thanks in advance...

from what i have read on here. individual insulated spades are fine to use...

hardnutdvd wrote:from what i have read on here. individual insulated spades are fine to use...

That's what I did.. still working 100%

Best to solder the wires into the connectors and not just crimp them

Has anyone got any pics of their wiring into the R6 reg/rectifier?
or could any one shed some light onto which colour wire should connect to which pin on the R6 rectifier?
help would be much appreciated

maks

someone posted a pic in another thread thanks its all working now =)