Page 1 of 1
Routing the ignition to the kill switch??
Posted: Sun Sep 04, 2011 9:51 am
by tanuki
Can anyone tell me how this is done?
My next job after Donington on Thursday is to strip the loom off the bike and take out all of the unused road gumpf (inicators, headlights, fan etc) and I want to rout the ignition through the kill switch but have no idea where to start.
Chris I'm looking at you..
Re: Routing the ignition to the kill switch??
Posted: Sun Sep 04, 2011 12:11 pm
by chrisja2
If its the same as i did for you last time, bring it round and we can have a look over a brew.
Re: Routing the ignition to the kill switch??
Posted: Sun Sep 04, 2011 1:43 pm
by tanuki
The whole loom?
dont suppose you fancy helping me to wire in a dash do you?
I'll pay....
Re: Routing the ignition to the kill switch??
Posted: Sun Sep 04, 2011 1:49 pm
by chrisja2
For sure, what are mates for?
Re: Routing the ignition to the kill switch??
Posted: Sun Sep 04, 2011 4:42 pm
by tanuki
Awesome mate!
Re: Routing the ignition to the kill switch??
Posted: Thu Sep 08, 2011 7:05 pm
by doug
I'm wanting to do the same with my 29, I don't suppose you have a wiring diagram or photos of what to do?
Any info much appreciated.
Re: Routing the ignition to the kill switch??
Posted: Sun Oct 02, 2011 5:27 pm
by doug
I think I figured it out.
I snipped the BLACK and the BLACK/WHITE wires that go to the kill switch.
I then joined the RED and the RED/BLACK from the ignition switch to the BLACK and the BLACK/WHITE that goes to the kill switch. 4 wires in 1.
Then joined the BLACK that goes to the fuse box and the BLACK/WHITE that goes to the HT lead together.
As it is a track bike I left the fan BLUE/ORANGE wire disconnected.
It seems to work a treat.