im looking at sorting out my endcan its carbon with stainless ends but has faded a little , id like to just rub it down and clearcoat it if this will fix the fade, anytips on getting it back to new looking , or better still where to find a blank replacement carbon sleeve , i cant seem to find anything

Have tried it myself but no luck. Especially with the heat on an exhaust. Better off buying a new sleeve @ £30 and some wadding and do a good job

any suggestions on where to find a new sleeve , iv found a few sites but still looking

P j engineering mate. Aa16 may do them also

Ive bought 4 from PJ engineering, I ordered 2 the wrong size. Really nice tubes great service.

+1 for PJ engineering. used them before and it was easy peasy...

yeah pj was the first place i looked , so as they get a thumbs up ill give them a buzz cheers chaps

Also used A16 Road and Race who were very good