I thought I'd fixed my sticky throttle issues, well I have partly, however when I fitted the rad back it sort of returned. Being slow to spring back on full right lock, I can only assume its routing problems

Can someone please go have a look at the routing on their bike and se if it looks like mine?

See here:



The above is from the throttle and the top cable crosses under the lower as it passes over the yoke

And here:



Is what it looks like on the left side, from the yoke towards the frame, again a cross over (and a rusty stanchion!!!)

I'd appreciate some feedback on what it ought to look like, I expect routing is pretty crucial

Thanks

Download the honda workshop manual.. the cabel routings are in there.

http://www.akhara.com/nc30/nc30manuals/ ... op_Manual/

Chapter 1

Neosophist wrote:Download the honda workshop manual.. the cabel routings are in there.

http://www.akhara.com/nc30/nc30manuals/ ... op_Manual/

Chapter 1

Those are some usefull diagrams, I was starting to forget where all the pipes, connectors go. Will be very handy when reassembling my bike. Thanks for sharing :)

From the manual it looks like they shouldn't cross over, I have to take the carbs off yet again to fit new rubbers, so I'll sort the routing out then

I'll get there eventually!

Cheers