im after some bearings and dust seals for my 23..

what are the sizes for
REAR LEFT HAND BEARING
REAR RIGHT HAND BEARING
SPROCKET BEARING

does anyone have the bearing sizes?

I'm off out to my mums in 15 minutes, I'll look for the old boxes and I'll text Ricky as I don't have your number. I do only have the wheel bearing numbers not the sprocket carrier one though, as mine looked new when I stripped everything down.

Seals are (2 of) 30X44X5

sorted, 2x 6022-2RS and 1x 6222-2RS as far as I can work out

do you know the dimensions so i can get some made? Width, diameter etc?

get some made? what, the bearings? why go to all the fuss of getting them made when they're an off the shelf part? seals are cheap enough to aswell

wemoto want just over 30 quid for the parts. Which means its eating the exhaust fund

I have 2 sprocket carrier's so i might not change those bearings depending on they're condition.

Best bet would be to change them all now and get the job done. then at least you have peace of mind that they are all replaced.

DK-Tandy wrote:wemoto want just over 30 quid for the parts. Which means its eating the exhaust fund

I have 2 sprocket carrier's so i might not change those bearings depending on they're condition.

Don't get them from Wemoto then...

They are generic bearings, look in yell.co.uk for a bearing supplier, call them and ask for some pricing on the codes you have got...job jobbed..

i thought the part number would of been honda specific? Or is that the part number in general...

nope, just a bearing number, so you can say I want 2 of XXX2RS, they can then punch it in and find it straight away.