does any one know any where that sells the four pinch bolts on the bottom of the fork legs(nc30) in stainless or titanium as ive just had the bottoms powdercoated the originals look shity and rusty,

Take ya pick http://shop.ebay.co.uk/i.html?_nkw=fork ... m270.l1313
Some of the Titainium bolts listed for other models may fit, most use the same pitch thread

www.tastynuts.com
Pro bolt stuff. Not cheap though.
I would check the bolt sizes on pro bolt and hunt for cheaper alternatives on ebay.

Have a look at http://www.stagonset.co.uk/
Used them a few times and not been disappointed.

any fastener and fixing shop will stock the bolts you need, no need for expensive pro bolt stuff, unless you like giving your money away ,imo anyway.

lizard821000 wrote:any fastener and fixing shop will stock the bolts you need, no need for expensive pro bolt stuff, unless you like giving your money away ,imo anyway.

agreed the pro bolt stuff is good quality kit looks nice but your paying for the fact its blingy polished their bike specific nc30 panel fastener kits are over 70 quid and are just a load of generic bolts washers etc they don't have the step on the bolts like the original honda panel screws that are only £2 each from david silvers