I have just went to fit my rear foot pegs on my RVF but on the left hand side one, it has a exhaust hanger attached,Which isn't needed because i only have a little stubby can,Has anyone tried cutting the exhaust hanger bit off the footrest?

couldn't you just use one from a VFR? I have a spare hanging around if you want to try it :)

I did this on a 600 Divvy. Easy enough, hacked it off using a disc cutter and as it's alloy you could polish it to a shine, though on the Divvy I never bothered.

Wasn't there a thread about fitting nc29 "stealth" rear pegs?

BillingCBR wrote:couldn't you just use one from a VFR? I have a spare hanging around if you want to try it :)

Cheers but I've sorted it now,just cut it off, looks fine :)