Ok sooo final problem to my rebuild then its ready to go!

My exhaust blows! Both front collars and also the 3 stud collar!?

Now... Can i replace the collars? And iv tried the insert gaskets and there too big sooo i thinks its the sleeve gasket. Now, my current exhaust has flaky, rusty ends which i presume is the old gaskets? So do the new sleeves go on the end which meets the 3 stud face if not is there a gasket to go in there because my collar is warped and blows!! And i presume they just go in front of collars on the front header pipes?

Its a full system that iv got with scorpion end can.

Cheers!!

Hi, i am not sure i fully understand which parts you need, but i think you are after part 1 and 2 on the following;

http://www.cmsnl.com/honda-rvf400rr-nc3 ... t/F17.html

If not what parts are you in need of?
Cheers

Corrrrrrrectamondo!!! Need 2 of one and 2 of two!! Can i order them through that site??

Is number 1 the sleeve or insert off that??

No. 1 is the copper crush ring gasket that sits inside the head. I usually smear a little grease on them to make them stick into the port.
You can get them from david silver spares or Rick Oliver on here.

Thanks very much bud!! What about 2? Is that the insert gasket that I already have? Cheers

Its the same as 1 but made from a slightly tuffer material to copper. this one also fits like an O ring between the rear manifold (3 stud plate) and the exhaust.
The only other type of gasket are the sleeve type between the front downpipes and the collector box part No.13