I have this in the shed, reckon I could use it as a rotor puller to save me getting the fancy bolt?



cheers

Yeah that looks like it would probably work.

davedrave wrote:save me getting the fancy bolt?

Nothing fancy needed, just an M20 x 1.5 in about the shortest length you can find.

Cammo wrote:Yeah that looks like it would probably work.

davedrave wrote:save me getting the fancy bolt?

Nothing fancy needed, just an M20 x 1.5 in about the shortest length you can find.

I have tried a similar tool to the one you have shown and couldn't get the arms between the rotor and casing and the bolts are cheap enough £5 from Rick O i think.

Dont use that.. it might not fit between the rotor casing.

If you file it down it might fit through the holes but it tends to buggar up the rotor as there quite soft.

You only need an M20 x 1.5mm bolt.. screw it into the hole and it pops out.

There about 1.00 :)

I recently got one from Rick Oliver along with some other stuff to do my GSXR conversion after ive got me bike back on the road and MOT'd. Its a big ass hex head bolt!!

R.O Stock List part:

NC30/35 Alternator rotor puller (bolt type M20x1.5) £5