Hi guys,

Anyone here used any of the Koso multifunction gauges with an NC30? Any problems wiring up or anything to note about them? Looking to fit a set to my NC30 project ('93 grey/N), like the look of them and the functionality. I haven't looked to see if the bike has been derestricted or not yet but not sure if that might have an effect post-gauge change also...?

I want to put a Koso dash or similar on me bike too!

Ive seen a Koso dash on Drunkn Munky and Martins bikes maybe try asking them?

There easy enough to setup, they can also use the standard speedo pickup so no need for extra speed sensors on the front wheel, just use this formula when entering the value for the wheel circumference,

Rear wheel circumference divided by the number of turns of the speedo cable does on 1 full turn of the rear wheel.

Example, if rear wheel circumference = 2000mm and the speedo cable turns 3.75 times to 1 full rotation of the rear wheel then it's 2000 divided by 3.75 = 533

Awesome, ta munky

Looks great

oh i want one of these...expensive though