hi guys!!

right ihave turned my NC30 into a race bike and removed the speedo and running total loss. bike ran perfect as a road bike bu now it runs so bad, misses and has hardly any power. i have tryed everything but could it be because i dont have a speedo anymore? how to i get around this becaus i have sold the speedo. any help would be great, was meant to be riding at mllory this weekend but cant now . for any mallory lads i was on a green SV650 but ill be on my NC30 (i hope) number 109 so if i get out on it come say hi. thanks Andrew

This could help:

viewtopic.php?f=24&t=17485&p=122167&hil ... al#p122167

Hope you got the bike going Andrew? See you at Mallory sunday if you have I'll be on a very slow red and white 35 No.75
Cheers
Jeff

Yakama wrote:This could help:

viewtopic.php?f=24&t=17485&p=122167&hil ... al#p122167

Good post and handy info as I am doing exactly the same thing right now. My only question:

The info in the link refers to and NC35. Is the setup the same on an NC30?

Thanks
Luke

On an nc35 you can connect the orange/blue wire direct to +12v. On the nc30 you need to run through a resistor.

Look in the Document library on the 400gb home page - there's a pdf called nc30 resistor mod that explains all.

spanky wrote:On an nc35 you can connect the orange/blue wire direct to +12v. On the nc30 you need to run through a resistor.

Look in the Document library on the 400gb home page - there's a pdf called nc30 resistor mod that explains all.

Just found it - thanks. It's funny - I have always has the forum bookmarked so never even knew there was a home page!