Attached it pictures of my current situation. A before photo for your enjoyment :-) Paint came off fine, but dents not so pretty. I was thinking plastech, which has recently become my best friend, but I'm not so sure it will work on metal.. In addtion, does anyone know where I can get another one of these small honda badges from as this is also dented?

Before on bike


After


Dented honda badge

Think you've answered your own question mate. Have a look at a Motorists Dscount Centre and get some of that Isopon metal filler, can't remember the brand name. Bit of paint on the top and bob's your uncle.
Don't know about a badge, maybe David Silvers

Cheers, have got some nasty smelling paste and am going to town, will hopefully show you finished product!

Primed and ready for top coat, think this should turn out just fine

you doing it with cans?? powdercoater would prob only charge a 20 for that. much harder wearing.

Yer.. But I'm on a super tight budget at the moment as i'm only a stoodent. I start work in August, so hope to get it to a stage for the winter I can do a proper rebuild but at the moment I just want to ride it! Out of curiosity, if I were to get it powdercoated in the future, would I have to refill it again?

really wouldnt know pal!? id expect theyed shot blast it so unless whatever you used to fill it was super hard , it might chip out. really dont know mind!

was just saying though cos after the price of primer,sand paper , paint and laqure..... prob more than 20 quid right.

Yup, but I'm spraying a fair few bits and bobs so think it may still work out a bit cheaper, thanks though, will deffo look into getting something more perminant done in the near future once I've got some coin!

Akey wrote:Cheers, have got some nasty smelling paste and am going to town, will hopefully show you finished product!

Sure you have the right forum?

I would have had a look on ebay or similar and got myself a better condtion second-hand one for like a fiver and saved all the faff...

youll struggle to be able to powder coat where the filler is unless its metal, as the powder coat works by statically attaching to the metal if theres no metal to attach youll get a dodgy finish there.