Got my NC30 road/race bike and i've just put the road gear back on it today. Got a problem though which I can't solve with Haynes unfortunately.

The rear passenger seat won't go on because the lock and latch assembly has been taken off. Now I probably have all the parts here somewhere minus the key lock (doesn't matter, just need finger to flip latch) but there's no way I can figure out how it's supposed to go together.

Can anyone help me out with some photos or something with what it looks like and how it goes together? Maybe someone has had to assemble it before? I'm sure it's simple but I've got a lot of parts here and I don't know where to start...

Any help much appreciated!!

would this link help? i dont have an NC30 though, sorry.

http://www.cmsnl.com/honda-vfr400r3-199 ... _1500.html

Dude thanks a lot!

I still can't quite make sense of how it goes together and sits in that frame but that along with a real life picture should do it.

the 2 hooks on the seat face forward and the seat slides forward under loops in subframe.
then the back of seat pushes down onto catch below at back of seat.

thrasher wrote:the 2 hooks on the seat face forward and the seat slides forward under loops in subframe.
then the back of seat pushes down onto catch below at back of seat.

yeap cheers dude, I've had plenty of NC30's and remember how the seat goes in... but I don't know how the catch is assembled and held onto the frame.

Any help really appreciated, just a quick photo in there to see how the diagram posted above makes sense in real life.

I can take some pics tomorrow for you if it helps.

cheers bud