Ok, what started out to be changing a sticky choke cable turned into finding a rusty mess
Where the clamps are holding the front down pipes it is all rotten.
My question is before I strip it down, what's involved and what parts are needed

[img]http://i95.photobucket.com/albums/ ... .jpg[/img]

Cheers guys (n gals)

Remove exhaust system, chop the rusty collars off and weld new stainless ones on. The repair will cost you around £50.

del. curt has spare exhausts drop him a pm

I'm on it, cheers Rick
Alex, thanks, this looks like option 2, was a bit dissappointed as the rest is rot free

as for gaskets on the collars,

sillicon sealant does the job better than gaskets :)

and only cost a couple of quid from screwfix :)

vfrderek wrote:My question is before I strip it down, what's involved and what parts are needed

Remove the rear exhaust section and fit a nice used half system.

More power, looks better, won't corrode in future and might not cost much more than repairing your standard system. Most of them slip over the front headers (use liquid gasket), no clamps required.

Have a look at these to see if they will help you Del






Curt

Hi Curt, I'm gonna take the complete system off tomorrow night so will let you know.
Them front down pipes look good

Just let me know what you need man

vfrderek wrote:Hi Curt, I'm gonna take the complete system off tomorrow night so will let you know.
Them front down pipes look good

get me some corrona's and ill make them look like this del