Hi at some point i will go down the ramair route.
Does it matter what pump i use?
Whats the best way to wire it?
Do i need a relay?
Cheers

Hi Marti, The one I have is from an NC29 (I was told) I got it from a mate who had it fitted to his track NC30.

As he no longer needed a rear brake light he wired it into the little red connector just up a bit from the right hand rearset. No relay used on his bike.

The fuel pump was then positioned where the overflow bottle goes under the seat unit.

The fuel tap also needs to be modded to be free flowing (HRC Style) so the pump can suck fuel through with out needing the vacuum pipe on the fuel tap.

Hope this helps.

My fuel tap has been modded and carb slides drilled.
When i do get a ramair box is there any other mod i need to do to the carbs apart from jetting?
Cheers

Yes the carbs need to be further modded for ram air, check this thread out for more info viewtopic.php?f=23&t=1788

I belive ABRmoto has a complete ready to go ram air setup for sale.