• NC30 flywheel puller

Posted: **Sat Jan 15, 2011 1:22 pm**

Hi does anyone know the thread dia and pitch of the puller needed to remove the flywheel?
Thanks James

Posted: **Sat Jan 15, 2011 1:59 pm**

I just measured mine and it's 20mm x 1.25

Jap pitch

Posted: **Sat Jan 15, 2011 2:03 pm**

skinnydog0_0 wrote:I just measured mine and it's 20mm x 1.25 Jap pitch

Thankyou very much for that

Posted: **Sat Jan 15, 2011 2:07 pm**

No problem, have you got a rotor holder for getting the flywheel off?

Posted: **Sat Jan 15, 2011 2:26 pm**

Not yet, im going to try and borrow one from a local bike dealer.

Posted: **Sat Jan 15, 2011 5:36 pm**

whereabouts are you?

Posted: **Sat Jan 15, 2011 7:06 pm**

banoffee wrote:whereabouts are you?

I live in York

Posted: **Sat Jan 15, 2011 7:59 pm**

ah, not close then or you could have borrowed mine (have both). got my puller from Rick Oliver and the holder from ebay (was only about a tenner).

Posted: **Sat Jan 15, 2011 8:10 pm**

Thankyou for the info

Posted: **Thu Oct 22, 2015 8:11 am**

Thanks to all for your replies.

NC30 flywheel puller