from what it looks like i have 3 allen key type bolts holding my end can on.. is there any gaskets also as i was going to take my end can off to get clean my swingarm but wandered if a new exhaust gasket was needed or anything

Yup, there is a large gasket inside (or should be, my bike came without one... )

Part number: 18292MV4000

Got mine from DSS?

or this should be replaced whenever you take the end can off, could i just re-use it this once

Lol I would have thought so, no prob... only replaced mine to get a good seal for the MOT.

I used an old cornflake packet cut to shape with a dab of exhaust paste to seal mine up, worked just fine

Get an aftermarket can

i think my can may be aftermarket, its got a carbon fibre effect on it, when looking on ebay, a standard can is just silver in colour and i presume ali? or stainless steel ? whatever theyre made from..

i was thinking of eventually have the swingarm powercoated but dont know where to get that done :/

Ah ok yeah that's not standard. Don't forget to take some pictures for us!

will do tomorrow when i get back from work :)