Hi guys, now I have the right tank, I need a favour from someone with a UK spec tank in RWB scheme if possible. I need a picture of the top of the tank, showing the stickers that are on the top so I can see what order they need to be in, and if possible something a little tedious aswell.

What I would like is for someone to mask off the outside edge of the square dip at the front and measure how much of a gap there is between;
- the edge of the border and the bottom edge of the bottom vinyl
- the edge of the border and the sides of each decal
- the distance between each decal

all in mm if thats ok

YOU HAVE MAIL MATE

Hope you can work them out yourself, from the pic......


By the way my other genuine uk nc30 WITH ITS ORIGINAL FACTORY STICKERS, are slightly lower down so i dont think there was a template at the factory to keep them all in the same place

Hi, cheers for the picture, any chance you could help even more? just need 3 measurements, as per the altered picture?

AS YOU LOOK AT THE PICTURE.............4, 29, 43. OK

awesome, thanks, thats brilliant