does anybody have an NC30 swingarm castlated nut removal tool/socket, that i could lend for a few weeks, need to get the swinger out for powdercoat, but dont fancy staking it out and shafting it up.

other wise, ill be cutting up a suitable sized socket if so what size should i butcher up.

thanks Rick

Ive got 2. one proper one and one basterised socket, cant remember which one does what swingarm or engine but your welcome to it mate

I have one too. Donate a few shillings to the forum and i can post it your way if the other one does not work out.

thanks guys,

tony do you still have my address?

i only need it to get the swing arm off, then as soon as its back from Powder coaters stick it back on and job done.

Think ive still got it, i'll sort out which one you need and get it off to you monday. No rush to send it back

Drunkn Munky wrote:Think ive still got it, i'll sort out which one you need and get it off to you monday. No rush to send it back

i guess its not something people often remove.

is the tool for the clutch the same by the way?

dont know mate, pretty sure the other one i have is for the engine mount

why are these silly nuts used?

To stop people taking things apart

Neosophist wrote:To stop people taking things apart

very funny mart!