Has anyone got either:

Spare NC21 clutch transfer bar and bush (the part that transfers the pressure from lever to the master cylinder) that they dont want or one they can photo and measure so i can get one made as i cannot afford the £40 for the parts from DSS.

Regards
Richard

Do you mean the pushrod?

Not sure what you mean, part number or microfiche pics would help

Neosophist wrote:Do you mean the pushrod?

Not sure what you mean, part number or microfiche pics would help

http://www.cmsnl.com/honda-vfr400rg-ya- ... t/F05.html

Number 2 and 3 on this diagram

ALso need the bolt that secures the lever to the mount

and both levers (in black)

Oh.

i have a complete master cyldiner / leaver and what not knocking around somewhere.

Are you putting the hydraulic clutch on your 24?

Neosophist wrote:Oh.

i have a complete master cyldiner / leaver and what not knocking around somewhere.

Are you putting the hydraulic clutch on your 24?

Ive put it on there now. I got it all running (had to use the 21 loom in the end lol)

but its running and running nicely

ANy news on if you have these parts you can measure and photo or supply me. (i can get them new for £40 plus the levers but thats a tad expensive to me for a little rod, bush and bolt)

You can have the whole lot for £10 + postage

(master cylinder / lever etc, could do with some paint but I can send you pictures if you want)

otherwise i dont mind taking pictures.

will have to dig it out though, it is in a box somehwere...

Neosophist wrote:You can have the whole lot for £10 + postage

(master cylinder / lever etc, could do with some paint but I can send you pictures if you want)

otherwise i dont mind taking pictures.

will have to dig it out though, it is in a box somehwere...

Find out how much the postage will be for me and then pm me with it please

Thanks for the help :)