fao brooky - graphics required
Posted: Wed Sep 15, 2010 1:07 pm
For the attention of brooky as above,
i have posted this as i know brooky will have to create templates / stencils for what i am after. whether anyone else likes what i am trying to do, your more than welcome to use them ( only rough ideas created on paint at work ) im sure brooky can make these look a lot better!
more suited to a modded nc30 than standard ( tyga maybe? )
brooky,
i want the 'vfr' to look as close as possible to the 'rcv' i have put in the bottom of the pic, colours same as rcv as well.
the font for these can be the same as used on the cbr 600 / 1000 rr, not sure on colour either white or red
i also require 2 x honda 'wings' for the tank and 2 x 'honda' for the belly pan, again white or red unsure at the moment.
the below is to try to give you an idea of the size i am after ( all panels basically full cbr 600rr in size )
feel free to pm me, with prices / times / if its possible etc
chris
i have posted this as i know brooky will have to create templates / stencils for what i am after. whether anyone else likes what i am trying to do, your more than welcome to use them ( only rough ideas created on paint at work ) im sure brooky can make these look a lot better!
more suited to a modded nc30 than standard ( tyga maybe? )
brooky,
i want the 'vfr' to look as close as possible to the 'rcv' i have put in the bottom of the pic, colours same as rcv as well.
the font for these can be the same as used on the cbr 600 / 1000 rr, not sure on colour either white or red
i also require 2 x honda 'wings' for the tank and 2 x 'honda' for the belly pan, again white or red unsure at the moment.
the below is to try to give you an idea of the size i am after ( all panels basically full cbr 600rr in size )
feel free to pm me, with prices / times / if its possible etc
chris
