NC29 Downpipes 4-1 system
Posted: Fri Aug 13, 2010 2:34 pm
Hi all
My previous thread about my Delkevic steel downpipes which made this annoying zinny rattle high pitch sound on 3500-4500rpm,,,,,,anyways,,,,,,been doing some homework about it and,,,,,,found these from `WEMOTO`
http://www.wemoto.com/bikes/Honda/CBR_4 ... ess_Steel/
They use a 4 into 1 system and come in 4 pipe sections with springs and all that that all goes into your single pipe.
Has anyone used these pipes in the past or the 4-1 system rather than the 4-2-1 system i have at the moment and i think they were on the origional mild steel pipes that came with the bike.
What about the performance of the 4-1 is there any difference from the 4-2-1 system would i get better top end, better acceleration or mid.
thanks again
paul
My previous thread about my Delkevic steel downpipes which made this annoying zinny rattle high pitch sound on 3500-4500rpm,,,,,,anyways,,,,,,been doing some homework about it and,,,,,,found these from `WEMOTO`
http://www.wemoto.com/bikes/Honda/CBR_4 ... ess_Steel/
They use a 4 into 1 system and come in 4 pipe sections with springs and all that that all goes into your single pipe.
Has anyone used these pipes in the past or the 4-1 system rather than the 4-2-1 system i have at the moment and i think they were on the origional mild steel pipes that came with the bike.
What about the performance of the 4-1 is there any difference from the 4-2-1 system would i get better top end, better acceleration or mid.
thanks again
paul
give GF a call got lots i have this race down pipes very good