Does someone have one of these laying around for the NC30? I need to know the pin configuration and whatever numbers are written on the damn thing. I am going to buy one specifically for LED signals, and I want to make sure I get the right one.

I know I could just wire in a resistor, but I am too lazy. I would rather plug and play!

Steve, not sure that you can get a plug 'n' play sort, the nc30 plug uses a small parallel 3-pin plug. Will get a pic up tonight.

I soldered on some spade connectors to suit my electronic relay.

Check out this link...

http://www.superbrightleds.com/cgi-bin/ ... ashers.htm

These are the options I have.

None of those are plug and play mate.

It's simple to snip off the honda plug and just crimp some spade plugs on. You'll need a 3 pin relay.

Good enough. I am handy with the wiring, but I am super lazy. I guess I am like water... path of least resistance.

lol!

Here's a pic of the connector plug:

Cammo wrote:lol!

Here's a pic of the connector plug:

That is for the NC30 huh? Doesn't look familiar.

Thanks for the pic.

I'll bring you one dude.... I think I have one?

Am setting off a week on Saturday and should hit Pisa for Tuesday, Wednesday?

If you can wait that long...

I don't need a stock relay. I am looking for one that works with the LEDs I have in my bike. I could wire in a resistor, but like I said, I am lazy!

What days are you gonna be here, so I can take some time off...

I told the wifey yesterday. The look on her face was priceless!

vfrman wrote: I could wire in a resistor, but like I said, I am lazy!

That's a very dodgy solution in my opinion. All it does is create heat and put the already poorly nc30 electrical system under even more strain!