Hi

Im getting busy on here today as ive loads of questions :)

Im going to be turning an nc30 into a race bike during the coarse of this year, as a result i was wondering if it was possible to modify the wiring loom or even better is there anyone who carrys out this work or actually creats a loom specifically for a race bike??

Cheers for you time lads

Damien

Get in contact with chrisxr on here he has just done mine. :D

cheers mate will do

Try this fella, not cheap but when you're a dunce with wiring it's money well spent. http://test.klikhome.co.uk/trackelectronics/
And welcome to the site.

ha ha cheers mick, im not even attepting touching the loom. no chance
Damien

Wise words, I attacked a CBR600 loom and it ran like a dog.
Ta for the PM mate about picking up bike, whenever is ok. I'm on nights till saturday morning. Give us a bell.

cheers for your patience mate, im just looking forward to getting on with it now, really need it to fill that 'project' sized hole in my life at the min.
ill give you a bell friday and sort out some timings from there.
Thanks again
Damien

Sounds good mate,speak to you Friday