Hey all just a quick one as im finding hard to find another 17 inch nc35 rear wheel im looking at the Delkevic Rep nc35 rear wheel and reviews on them ?

honest answers please on people who may use them or heard or seen bad things about or they atuacly good ? thanks

I have a couple of them. After removing the powdercoat from the areas that it is not supposed to be (inside the hub, etc), they work fine.

on my crappy scale they are actually lighter than the Honda wheel.

your results may vary.

Pretty much the same as above, I have one for my wets. Only problem again was that I had to dremel the paint from inside the 4 mounting holes, otherwise the wheel would stick on.

Once I did that, they've been easy to fit and remove each time!

They do the job for race purposes but the cast finsh under the powder coating ain't as good as original,
so i would say if your looking for one with a good finsh you cant beat genuine bud.

Edge.

I have a couple of original that will be for sale in next week or so.
Also a NC23 light weight front, fresh powder coated as well.
Few goodies coming up as her in doors want a conservatory!!!

ha and you want a working mv again?


iv got an delk rear wheel and it works fine, powdercoats not amazing but its only on a race bike.

Spike,

MV is working fine now! Bike maintenance by Mastercard
Just need to keep the wife of my back now

I have a couple of original that will be for sale in next week or so.
Also a NC23 light weight front, fresh powder coated as well.
Few goodies coming up as her in doors want a conservatory!!!

What make is the NC23 light weight front? Also how much lighter than standard is it? And how much are looking for it?

Cheers