Does anyone know what the best quality solo seat is for the NC30 ? ive got a Tyga RVF solo seat but i want one in the shape of the NC30 rear with the holes for the lights already cut??

Cheers
Kris

Dont tyga do a NC30 shaped solo seat with light cutouts??? if not just cut them out yourself

i will speak to Gav, i dont think they do. If thats the only solution, i will cut them out but id prefer them already done by the factory.

Kris

Pencil + Ruler + Dremel = Done.

alexwitham wrote:Pencil + Ruler + Dremel = Done.

+ dust mask!

Fibreglass dust is not good for you!

Druid

Pencil and ruler?? will the pencil work on the fibreglass?? what if i get halfway through and i cant see the mark??

id cut a template out of thin carboard first and get the fit around the light unit right then transfer that to the seat unit. If in doubt go smaller as you can always open it up a bit.

i was only joking drunkn! but thanks anyway!!

TYGA do a road and track NC30 single seat in the RVF shape they do not do a NC30 shape one though. If you order the street all the holes all pre cut for you

Thanks Gav, i thought that Tyga didnt do one, Ive got a Tyga Rvf one just wanted an NC30 shape in similar quality!

Ta
Kris