can anyone help me with the float height settings and air screw settings for a nc24....thanks

6.8mm (measured from the gasket side)

Between 2 1/4 and 2 1/2 turns out from fully seated :)

Theres a full set of specs on my website

http://www.jacksons-lair.co.uk/specs.html" onclick="window.open(this.href);return false;

Might help :)

There should be 115's all around... The front cylinder emulsion tubes have 4 air holes in them, the rears have 5 holes.. these often get mixed up by people who strip them all at the same time and don't notice.. :)

thanks