Page 1 of 2

Turning over now - wont fire

Posted: Sun Nov 15, 2009 11:38 am
by 400cc
GSXR sp gk73
Ive charged the battery and its turning over now but it wont fire,its been stood for a cpl of years in my garage,any ideas anyone
Thanks

Re: Turning over now - wont fire

Posted: Sun Nov 15, 2009 12:11 pm
by maxb
have you changed the fuel etc?

cleaned the carbs?

checked for spark ?

Re: Turning over now - wont fire

Posted: Mon Nov 23, 2009 4:22 pm
by 400cc
Got her going now

Re: Turning over now - wont fire

Posted: Mon Nov 23, 2009 7:29 pm
by CMSMJ1
Bonus...what was it?

Re: Turning over now - wont fire

Posted: Tue Feb 16, 2010 1:38 pm
by luckybiker2010
I have been riding on off for just over two years now.

I seem to have this problem with my bike too, it is a gk76a. I have tried everything i can think of and my problem points towards an electrical fault. i have replaced the ECU but still it wont fire up.

Can anyone help me with my problem?

Cheers

Matt

Re: Turning over now - wont fire

Posted: Tue Feb 16, 2010 10:33 pm
by Variablevalves suck
Hi Matt,
You will have to expand on the problem- do you have a spark? are the plugs wet with un burnt fuel, etc.
Chris.

Re: Turning over now - wont fire

Posted: Thu Feb 18, 2010 8:58 am
by luckybiker2010
Hi, No Sparks from any of the plugs, however all the lights work, plugs arent wet... both coils have a resistance through them so does everything else... although i do not have specific figures of what they are supposed to be...cant think of what the problem could be. :cry:

Re: Turning over now - wont fire

Posted: Thu Feb 18, 2010 6:43 pm
by Variablevalves suck
A few things to look at are- fuse, can you hear the relay's switch when you turn the ignition on, is there 12v at the coils, disconnect the righthand switch and check with a meter that the kill switch is good. If these are good next check the signal generator (two wires from the left case) should be about 100/110 ohm.

Re: Turning over now - wont fire

Posted: Fri Feb 19, 2010 8:55 am
by luckybiker2010
Cheers I will have to check on sunday as that is the only day I have free... Watch this space.

Re: Turning over now - wont fire

Posted: Sun Feb 28, 2010 4:33 pm
by luckybiker2010
I have checked it and the fuses are fine, the relay switch is working fine too, the kill switch is good as it attempts to turn over, there is no voltage getting to the coils and there is about 175 Ohm at the signal generator. Is this the problem or does it not matter?

Matt