Does anybody know if I can use the clutch cover gasket of any other model? I already scratched of the original and hope to sell the bike on saturday. Due to this I have to buy an aftermarket gasket an they don't sell NC29 parts here in germany.

Thanks for your support

WEMOTO post out on the same day.

davidsilver also sell them or from ebay http://cgi.ebay.com/ws/eBayISAPI.dll?Vi ... K:MEWAX:IT

Graeme France may be willing to send something like a gasket to Germany? Worth asking.

Than you folks,

Greame said, it is only NC29 and nothing else. So I have to do something marvelous - like cutting one out of a piece of gasket-paper.

You crazy young fellas. I can't imagine 'cutting' one, with scissors, out of gasket paper.

You just need gasket paper, a ball peen (peen?!) hammer and a hole punch.

Use the hole punch to make two holes to mount your gasket paper on the locating dowels on the engine, then go round the edges of the crank case with the ball end of your hammer. The edge of the case will do all the cutting and it will fit like a glove.

Made quite a few like this when I was riding two smokes.