Just been to get my manifold and end can fitted to my NC30. But i think it is still blowing from near the manifold. If i put my hand over the end can should the revs die out completely?? When i do it to mine it just cuts the revs a little bit!! There is smoke coming from near the manifold but i think this maybe excess oil and exhaust paste burning off!! it seems to run nice!! any Ideas??

Did you make sure you put gaskets in and take out the old squished ones before fitting the new ones in?
Was the 'manifold mounting plate thingy' straight or slightly bent from past over tightening?

Alex

to be honest i didnt have the time to do it so i got s bike garage to do it for me, it cost £60.00!!!!!

take it back

Somebody help finish this well known phrase:

If you want something done properly...

So can anyone tell me if the revs are meant to die out completely when you seal your hand over the end can or not?

Yes they are.

Druid