I fitted a new dial to my NC30 speedo a while ago and seem to remember the needle had to be fitted in the position on its spindle as removed.

My NC 35 has a MPH dial and it shows 63 mph at 7000rpm, when a following bike showed 70mph.
[I know the 35 is geared up around 5% over the 30, so should read a bit higher not lower, according to revs, my 30 shows 7000rpm/70mph]
What speed would 7000rpm be on a 35, and has any one fitted a new dial or can say where the needle should be fitted on the spindle.

Thanks,
Dave.