hi all, puttin the lump back in 2morrow mornin, just couple of question on
a) any1 got any pics of the way the loom runs round the engine & frame
b) what bolts go where + spacers
im pretty 'sure' of where it all goes + iv got me haynes but as its critical i thawt id ask just 2 be 100%
thanks, sean

For what bolts and spacers to use look here: http://www.akhara.com/nc30/nc30parts/files/49.htm !

Remember that the lower right mounting bolt goes in first then the engine then the adjuster bolt threads through the mounting bolt then through the frame through a washer/spacer then the engine and nut goes on other other side. Castle nut goes over adjuster bolt. Caking the mounting bolt and adjuster bolt in grease helps a lot. My adjuster bolt got very very (very!) tight going in. Hope yours fares better!

Left Front: 10x40
Left Middle: 10x50 + the biggest spacer
Left Rear: 10x35
Left lower: nut over engine mounting bolt

Right Front: 10x40 + thin spacer
Right upper/middle: funny adjuster-like bolt + 10x60 + Castle nut
Right middle: 10x40 + big spacer
Right lower: is the adjuster + mounting bolt then castle nut (don't forget a spacer/washer goes on the inside of the frame it's number 18 in the diagram)

Think that is everything for the main important bolts.

Lots of edits this evening

or could some1 edit this roughly to show the loom?

I've got pics at home, I'll post them later after work.

thanks gray, spot on m8 :D , thanks jeff :D

it goes up below the front frame mount and round towards the headstock. so bassically on the outside. hope this helps.

Hope these help, I have smaller more specific ones also if you get stuck somewhere.

spot on pics, great help, thanks jeff :D

thanks hanna 2 :D

engine went in a treat no probs at all, loom looks pretty straight 4 ward now 2, thanks all!!! :D :D :D