Page 1 of 1
ouch !
Posted: Sun Aug 09, 2009 9:36 am
by Dynamohum
dumped the 400 in the wet going over the b743 moorland road to muirkirk .

don't really know what happened had a small rear end slide so backed off a bit a few miles later a long lefthander i am on me arse in a ditch with bike close by just glad there was no oncoming traffic, mate who was following on his blade said i was down in an instant got a few aches n pains in left hip but ok . going round to garage to asess damage further. so far top cowl and screen split uk spec

mirror scrap , left mid and lower scraped lh bar end and tyga lever both indicators lh peg gear lever lh seat panel scraped , can popped off with a few scrapes. on the upside both rads and oil cooler appear ok forks wheels tank frame unscathed . had to leave bike unattended at scene and got a lift into muirkirk to phone rac recovery due to being unable to get a signal bloody useless virgin mobile when i returned with rac guy somebody had made of with the race can some people eh !
Re: ouch !
Posted: Sun Aug 09, 2009 9:46 am
by wullvfr
main thing is fella....ur ok.bike can always be repaired or replaced.nothing you can do when it goes away from you that quick.
wull
Re: ouch !
Posted: Sun Aug 09, 2009 9:47 am
by fixer
Sorry to hear you have had a off Dave.Lucky to get away with light injuries.As the thieving scum who stole your end can lets hope they get nicked.
Re: ouch !
Posted: Sun Aug 09, 2009 9:59 am
by Dynamohum
re- the can had a couple of people stop and ask if i was ok in the village that had seen bike sitting in the ditch thanked them for stopping and explaned i was waiting for rac recovery coming two stopped on an old ratty gpz500 wearing a nylon cagoul n trainers pos could have been them ? thing being its of no use to anyone unless its for a nc30 crazy.
Re: ouch !
Posted: Sun Aug 09, 2009 10:02 am
by Cammo
Sh!t no good dave, glad to hear you got out of it well enough to post, can always be worse!
Good time for a muffler upgrade!!
Re: ouch !
Posted: Sun Aug 09, 2009 10:50 am
by Dynamohum
thanks guys , the phoenix shall rise from the ashes

got the original uncut system in a local engineering shop at the moment getting stainless mid joints welded on that rcv4 supplied a big thank you to him. or may look for another can, have around one and half sets of bodykit in the shed in various states of disrepair so might get cracking on them with the plastex/dremmel and get them painted up in the original rwb. shame that the set i just trashed was a good set i bought from kermit who used to be on the old forum some of you may remember his thread and youtube video? untill yday all his fine workmanship was holding firm doh !