Howdy guys

Does anyone know the size of the bleed nipples on the front and rear callipers on the RVF 400 ?

I want to replace mine with stainless ones, mine have all gone rusty

I've seen an ad on evilbay and they sell :

M7 x 1.00

M8 x 1.25

M10 x 1.00

But I can't seam to find any data anywhere which confirms which size I need.

Anyone got any ideas ?

Ta very much

M8

HTH

BTW : Probably a more appropriate question for the workshop, and a quick search there would have revealed a post confirming the size......

Thanks quicksilver

Wasn't sure where to post this question I did think about it, just thought it was a general question not a workshop technical one ?

Thanks anyway I'll get some ordered