I have an Ethos can with a rotten perforation tube, anybody where I can get it fixed?

http://www.aa16.co.uk/" onclick="window.open(this.href);return false;
perhaps? Their site used to be good, it seems they are underdevelopment now for a couple of months

Also try PJ Engineering, they made me a set of cans before from scratch. The weren't just a regular set either as the sizes were bespoke to the system. I'd dare say they would knock you one up if you had the inner diametre and length.

anr performance do exhaust parts, cant say for my self but smev's 'Arrow' can is made from their bits I think and its looks very good (if i could sell my scorpion carbon for enough to build one of their I would)

O my seat unit is from them and its very good quality also if that makes any difference

I use a guy in louth if thats any good ?

Good prices about 50 - 70 to re sleeve and re pack !

hi,i can supply exhaust parts or repair,if you have a problem.....i have been a exhaust fabricator for 15 years.

I've repaired a few Jap import exhausts in my time and the majority of them have knackered internals. Just get some 50 mm perforated pipe from any exhaust place and spot weld a couple of spots on to keep it where it should be. Most import exhausts are about 30% straight pipe and 70% perforated. Add packing and you're done for not much cash.

rcv4 wrote:hi,i can supply exhaust parts or repair,if you have a problem.....i have been a exhaust fabricator for 15 years.

in case you have missed out geoff this lad has a post in the exhuast sticky section, check out the lads handywork, unreal stuff

Thanks for the replies.

Declan, spoke to him yesterday, he's going to be doing it (along with some other stuff)

rcv4 wrote:hi,i can supply exhaust parts or repair,if you have a problem.....i have been a exhaust fabricator for 15 years.

oh really !!!

( i can see you getting bombarbed with email now ,"can you make me this system")

good luck geoff i hope you get something sorted.