How the heck have I managed to miss this thread 'til now?



Off to http://www.projection-components.co.uk/ ... ts-2-c.asp for a browse!

Drunkn Munky wrote:

porndoguk wrote:

Drunkn Munky wrote:So are you guys drilling the spindle for the hub nut and using a R clip?

YEP, will need to use an Rclip other wise you wont get the paddock stand in brother :)

Eh?? you mean to get the paddock stand in you need to remove the R Clip?

EDIT: Ok it might help if i read the 1st post of the topic as you were ignore me

i love you tony, your so special!

THEY'RE HERE



Will get the torque wrench out this evening :D

porndoguk wrote:THEY'RE HERE



Will get the torque wrench out this evening :D

Awesome

C'mon Rick!!

Got your spare calipers here by the way

Rumour has it the hub nuts are fine... I'll get a pic up when I get the pic to put up

As the NC30 top yoke nuts are delayed, I'll change the offer to just the rear wheel parts (hub and wheel nuts, pinch bolt) and leave the top yoke nuts separate so both NC30 and NC35 owners can take advantage. I'll put the hub nuts on sale now, and adjust the offer settings on the site to take £5 off the total price when you buy all three at once.

edit- right, that's done.

tested the hub nut and hub pinch bolt both are Spot on,

only issue ive had is the bloody hub is a nightmare to drill so going to get some better 3mm drill bits,

ill also put all the torque settings to save you having a mooch through.

Hub Pinch Bolt, 17mm hex, 3mm lock wire holes, 55nM
Hub Nut, 46mm hex, 3mm lock wire holes, 165nM VFR - 205nM RVF
Wheel Nut, 36mm hex, 3mm lock wire holes, 120nM
Yoke Stem Nut, 140nM VFR - 105nM RVF

porndog you beat me to it,
But i'v got to show mine off just the same,
And say a big thanks to Kayla,We must get some Kissing smilies,Then we can all send them to Kayla,thanks again.
The swing arm don't do them justice,it' my spare.

I've got to say a huge thank you to Rick for testing these for me, and to the others who helped with parts and measurements and finally a massive 'phew!' that they're ok

Kayla, just ordered,could't wait for the to yoke.

Any plans for more Titanium? Front axle for example?