Re: Smurf Blue NC29 in NZ
Posted: Sat Dec 24, 2016 12:44 am
In order to clear some room in the shed and 'moth-ball' the 29, I decided to put it together.
Keeping in mind that these horrible smurf fairings are not staying on the bike, I will replace them eventually.
Front guards on now and the electrics are sitting where they should. I figure I can splice and solder etc with them in place which will be a lot easier then removing and reinstalling the loom again.
My stainless steel exhaust studs and copper crush exhaust gaskets arrived in the post, so I installed the exhaust. I actually felt quite chuffed after installing the exhaust, so I then installed the radiator as well!!
Rear fairings are on, I put the nose cone on and even decided to put the mirrors on too to make it look complete again.
And this is how she'll look while she is 'Moth-balled' for a month or so....

Keeping in mind that these horrible smurf fairings are not staying on the bike, I will replace them eventually.
Front guards on now and the electrics are sitting where they should. I figure I can splice and solder etc with them in place which will be a lot easier then removing and reinstalling the loom again.
My stainless steel exhaust studs and copper crush exhaust gaskets arrived in the post, so I installed the exhaust. I actually felt quite chuffed after installing the exhaust, so I then installed the radiator as well!!
Rear fairings are on, I put the nose cone on and even decided to put the mirrors on too to make it look complete again.
And this is how she'll look while she is 'Moth-balled' for a month or so....
