Yeah. iv still got those nc35 race fairings i bought from you over a year ago so it makes sence to use them and not buy a new nc30 set. also got a tyga nc/rc45 seat unit to go on , i think the lower bracket on the cock bracket needs to be changed slightly .

Tempted to go with the red Honda Britain colour scheme as it will be simple to fix if and when i crash it again.

Neither will fit mate, you could modify the clock mount but theres really no point. I know VFR bodywork fits a RVF with a RVF clock mount so i see no reason why RVF bodywork shouldnt fit a VFR with a VFR clock mount.

hmm , got me curious now .

will be heading out into the garage in a bit for a tinker., of not then they will be fitted to the nc35. Sure that i read somewhere on here that thats what was needed to fit them.

Buy my Silhouette stuff mate, all ready for paint!

ibby4585 wrote:Buy my Silhouette stuff mate, all ready for paint!

Id love it but its more than likely going to get trashed on this bike,

marcus57 wrote:

ibby4585 wrote:Buy my Silhouette stuff mate, all ready for paint!

Id love it but its more than likely going to get trashed on this bike,

Slow down a bit then! Lol

marcus57 wrote:hmm , got me curious now .

will be heading out into the garage in a bit for a tinker., of not then they will be fitted to the nc35. Sure that i read somewhere on here that thats what was needed to fit them.

I made the same mistake and bought a VFR mount and brace but it worked out easier the adapt the RVF ones, id assume it the same case for you but the reverse of what ive done.

nc35 upper brace on a nc30 frame , slight fitment issues.





Had enough , just going to sell them and the fairing kit and get a nc30 one

You can still fit the RVF bodywork on using VFR mounts mate, the screen brace mounts need to be moved back 15-20mm, easy job. The front mount from what ive worked out doesnt need changing at all, well it didnt in my case fitting VFR fairings on a RVF so i can only assume it''l be the same for you, if anything you may have to move the front nose mount up or down 10mm, again easy to do with a bit of alloy and some basic fixings.

Well progress has been slow with this one but i have a trackdy booked for Snetterton on the 22nd

Bike was a mess and had no rear wheel , hub caliper ect ect

I have been on nights so i spent a few hours , which i payed for the next night lol







Still massive amounts to do but it should be ready