happy happy happy

Nice marcus, what model is that? The remote is different to mine!

You need to start fitting these parts dude and get some pics up of the bike!!

Kris

ibby4585 wrote:Nice marcus, what model is that? The remote is different to mine!

You need to start fitting these parts dude and get some pics up of the bike!!

Kris

its the track model.

yeah i know i can hardly get in the garage with all the parts iv got stockpiled but now iv got the shock i can crack on with it all, need a abba stand but im looking at cars on sunday so im going to be ultra skint so i think i will have to make do with some axle stands.

Shock horror iv started fitting parts to the bike.
Decided to start with the rear shock , i dont have a abba stand so i decided to make one out of some 4x2 , worked a treat.

















its not much but its a start

I just made a rather bad sex wee in my pants looking at those

Marcus, here's a pic of my Cabin NC30



This is the only pic I have of it, I took it when I collected the bike about a year ago.

Not been much progress for a while with this as i bought a car and then spent a fortune on bits for it.

My question is tho what parts do i need for my carbs? will be running the sp1 system and what clutch kit to buy ?

Managed to get into the garage for a bit and was goignt to split and clean up the calipers but i couldnt get the pad pin out so i sarted get all the other brake and clutch parts off ready for my new clip ons and forks. my question's today are

Can i get this to look clear again and its gone quite misty and what can i replace the nasty bit of pipe work with?

marcus57 wrote:Managed to get into the garage for a bit and was goignt to split and clean up the calipers but i couldnt get the pad pin out so i sarted get all the other brake and clutch parts off ready for my new clip ons and forks. my question's today are

Can i get this to look clear again and its gone quite misty and what can i replace the nasty bit of pipe work with?

in a nutshell no.

i recently tried pulling the dullness and yellowing out of my radiator expansion tank with no joy, down to the platics used called HDPE (high density polyethylene)

gav at jap4 sells new carbon and/or kevlar covered ones for under £15 sheets on ebay, remember we get discounts too, so bargain if you ask me,

heres pics of them on tonys/DM's - AM/PM bike.

this is 'hrc' res hose which you can get from the bay of e.

or banoffee sorted me out some standard black hose, maybe pm him to see if he has any left over?