In my rebuild i did this

Looks nice and we finally got a pic the right way up :)

Regarding the fork height, me id set the fork height to stock to keep the geometry and have some clipons made to suit.

Porndog, I think that's the way I'm gonna have to go however the distance needed to close is considerably longer!!!

Didn't think of having any made! That would solve the problem, got any suggestions on who could do that?

i think tyga do some

porndoguk wrote:i think tyga do some

LIKE!

You don't need to get a set made. Just get a set of clipons from a B1h, the clamp part is narrower than on an NC. All your switch gear and controls will fit straight on and there should be plenty out there.

Didn't even think of that, thanks a lot Martin!


Luke

eh? i thought it was the 636 clip on you was saying was too big, surely you wasnt going by the size of the NC30 one?

No it's not the fork leg diameter, it's the clip on clamp width up down, I need one that is very slim in that respect.

I'd been looking at renthal and Gilles clip ons as the clamp is very narrow in height but they're too expensive, I'd not thought about the standard zx clip ons or ever seen any.

Not to sound like a tart I'm not sure if they look trick enough either lol not for the price they seem to be on eBay anyhow.

Why not keep your money in the country, contact kayla at projection components, shes a brilliant machinist and can do custom work, she also stocks and makes clipons and bars

Rick