We need more pictures!

If anything was happening I would!!
Put me back out last week and was awaiting new sub frame as had another change of plans!!
Will be on it again this week.

Finally got a load of work done today, still waiting on some parts, both forum members that will remain nameless, for now Some one needs to respond to PM's
But, exhausts fitted, rads fitted, inc new bottom rad got off Viper about 4 months ago. Fitted Harris filler that came from Rileys Bike, although may sound like it but this bike has not got a limitless budget and second hand parts have been used a lot.
May get some oil and water in her and see if she runs tomorrow. Need to drain tank, fit HRC Modded fuel tap and sort all fuel lines again, but recon should run tomorrow. So just need bodywork and some other parts now.

What yokes are they Aly?

Tyga, top quality piece of kit to, well worth the outlay. If you look back there is a pick of the dash and can see top yoke a lot better.

Glad you said that,I ordered one from Gav.Bought a load of Ti stuff this week,and have been making some over the winter.Might call mine the titanium build,or has someone done that?

Go for it Carl, any Ti bits that may be of interest to me road or race

thats bike looks awesome dude, keep up the good work

How well put together is that bottom rad, I loved it (even if it only seen 3 heat cycles)

The bike is looking great. Carbon, if done right, always looks the danglies. Was over at BMW of Friday and they had an all-singing S1000RR dripping in carbon and all the bits, I think I'd have swapped the 'Blade for it then and there, but they'd probably give me £30 for the CBR and want £16k for the one I wanted.

One small question - as I see there is ISR brake master cylinder and lever. Are they so good as thiers price ? What about compare with Brambo ?