Thanks for that, yes did come from ebay.

Thanks.

abrmoto wrote:Thats not same as one o had, mine was in about 13 separate sections, all spring mounted.

This one's in 8 pieces,it was bought in 1991,maybe they made some different ones at a later date.

This one is all spring mounted .

Saw these 2 End Cans on another Exhaust thread:

like this one better


just wondered if anyone knew where i could get one, or if it would work on teh Vfr butler46

^^ I reckon you might get one from scorpion maybe Any can can be made to fit but IMO that would look shit on a NC

yer suppose that makes sense, maybe i should check via them, i just like the look of them, i suppose the nearest thing are them Viper ones that also have the end cap on them, but they are listed on ebay as fitting the Nc30 :D any body tried them VIPER cans ?

i found the site, http://www.scorpion-exhausts.com/moto-i ... dtype=MOTO but they dont seem to have any pricing etc ? although them cans are on :D

jimlad wrote:Hi, just got this half system and thought i would post some pics and hopefully somebody could tell me what make it is?










Thanks..

Hi
I was going to fit this half system but thought it looked abit on the short side, could anyone tell me if they think it has been cut or is there a section/link pipe missing?
Thanks in advance.

jimlad wrote:

jimlad wrote:Hi, just got this half system and thought i would post some pics and hopefully somebody could tell me what make it is?










Thanks..

Hi
I was going to fit this half system but thought it looked abit on the short side, could anyone tell me if they think it has been cut or is there a section/link pipe missing?
Thanks in advance.

Looks exactly as it should.

Hi everyone, does anyone know the inner and outer diameter of the slevee on a MHP exhaust can for the NC35 ?

Thanks

My full Micron system that came with the bike, complete bar steward to fit tho, still not convinced its on right!!

If it's fitted,then i would say it's right.they are such a tight fit.
Have you got any pics of it fitted,I have one of these, I also have the fitting instructions.
Go back to page 40,you will see mine assembled.